Installing symtec heated grips on atv

Need a specific type of connector? No problem. Your brand deserves something that matches it — style, features, and functionality. We can customize the design to adjust to fit your brand and application. In , a leading powersport manufacturer approached Symtec with a request to produce a simple, heated grip product. Read More Here. Extend rides with the comfort and warmth with Heated Grips. Heated Grips mean warmer riding in all conditions. Connect the red and black power wire directly to the battery of the vehicle, red to the positive battery lead, and black to the negative battery lead.

If the heaters are heating up on their own, they are grounding to the handlebar. This completes the circuit, causing the heaters to draw power with the controller turned off. Inspect all of the wires, specifically the yellow wire, to make sure they are not pinched, snagged, or grounding out on the handlebar.

If the kit was installed on a bike with electronic throttle and used the adhesive throttle-by-wire heater, remove the throttle sensor assembly and inspect the heater. Make sure that the heater was not damaged during installation. Connect the white wire to the positive battery lead and the black wire to negative battery lead. Check the voltage out of the controller with a multimeter by connecting the positive lead to the white controller wire and the negative lead to the yellow controller wire.

Then turn the controller on to make sure that the controller LEDs light up and can switch through the four levels. Yes, but you must put heat shrink over the clutch-side handlebar before the clutch-side heater is installed.

This process is also required for aftermarket aluminum throttle tubes. The seat heater is 30W and designed to be used in all weather conditions.

If the seat heater is too hot for your application, trim the length of the heater one inch at a time. This will drop the wattage of the heater overall. Please note that you can only trim the edge opposite the wire exit. Do not cut between the two bus bars, as that will cause the heater to stop functioning. Check the voltage being sent to the seat heater. This can be done with a multimeter at the pin and the barrel connector from the switch.

For the multimeter, the pin is positive and the barrel connector is negative. With the seat heater on high, there should be 12VDC. With the seat heater on low, there should be 6VDC. Technical Support. My ATV heated grip kit came with two left side grips. How can I have both the grips and the thumb warmer on at the same time? The controller LEDs just flash when I try to adjust the heat level. It shows the top pin is for the low circuit and the bottom pin is for the high circuit.

Which wire is ground for the heated grips? The red wire for each heated grip is ground, the blue wire is low, and the white wire is high. The heated grips no longer turn on and heat up.

Which wire is ground for the heaters? The red wire for each heater is ground, the blue wire is low, and the white wire is high. The heaters no longer turn on and heat up. The kit is installed, but the heaters do not heat up or the controller LEDs do not light up. Make sure that the kit is not grounded to the frame of the motorcycle.